OvisLink Evo-W311AR/boot log

Boot log

Booting... @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @ @ chip__no chip__id mfr___id dev___id cap___id size_sft dev_size chipSize @ 0000000h 0c84015h 00000c8h 0000040h 0000015h 0000000h 0000015h 0200000h @ blk_size blk__cnt sec_size sec__cnt pageSize page_cnt chip_clk chipName @ 0010000h 0000020h 0001000h 0000200h 0000100h 0000010h 000004eh GD25Q16 @ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ ---RealTek(RTL8196E)at 2012.07.06-04:36+0900 v0.4 [16bit](400MHz) Delay 1 second till reset button Magic Number: raw_nv 00000000 Check Firmware(05020000) : size: 0x001c3fc8 ---->[ OK ] Jump to image start=0x80500000... decompressing kernel: Uncompressing Linux... done, booting the kernel. done decompressing kernel. early printk enabled Determined physical RAM map: memory: 01000000 @ 00000000 (usable) On node 0 totalpages: 4096 zone(0): 4096 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/mtdblock1 console=0 single Calibrating delay loop... 398.95 BogoMIPS Memory: 9500k/16384k available (2310k kernel code, 6884k reserved, 416k data, 60k init, 0k highmem) Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes) Inode-cache hash table entries: 1024 (order: 1, 8192 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 4096 (order: 2, 16384 bytes) check_wait... unavailable. POSIX conformance testing by UNIFIX Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd Serial driver version 6.02 (2003-03-12) with no serial options enabled ttyS00 at 0x2000 (irq = 5) is a rtl_uart1 state->flags=00000000 Realtek GPIO Driver for Flash Reload Default Init IPTIME GPIO: block: 64 slots per queue, batch=16 PPP generic driver version 2.4.1 MPPE/MPPC encryption/compression module registered SPI INIT flash device: 0x200000 at 0xbd000000 probe realtek capacity_id 15 capacity_id 15 get SPI CS0 maker:c8 type:40 sector_cnt:0 MXIC matched!!get SPI chip driver! Physically mapped flash: Found an alies 0x200000 for the chip at 0x0, EON device detect. probe ends probe realtek2 Creating 2 MTD partitions on "Physically mapped flash": 0x00000000-0x00200000 : "boot+cfg+linux+rootfs" 0x000d0000-0x00200000 : "root fs" RealTek E-Flash System Driver. (C) 2002 RealTek Corp. Cannot find driver for DiskOnChip Millennium at 0x6000 Realtek WLAN driver - version 1.6 (2013-02-21) wlan_index:0 0, 134,0xb9000000,0xb8b10000,21 =====>>INSIDE rtl8192cd_init_one <<===== PCIE reset (0) Do MDIO_RESET 98 - 25MHz Clock Source Find Port=0 Device:Vender ID=817910ec vendor_deivce_id=817910ec =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0xe] Realtek 865x Ethernet driver v0.6 (Mar 26, 2008) eth0: RTL865x-NIC at 0xbb804000, 00:00:00:00:00:11, IRQ 2 eth1: RTL865x-NIC at 0xbb804000, 00:00:00:00:00:22, IRQ 2 eth2: RTL865x-NIC at 0xbb804000, 00:e0:4c:f0:00:02, IRQ 2 eth3: RTL865x-NIC at 0xbb804000, 00:e0:4c:f0:00:03, IRQ 2 eth4: RTL865x-NIC at 0xbb804000, 00:e0:4c:f0:00:04, IRQ 2 => rtl865x_ioctl init NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 2048) Linux IP multicast router 0.06 plus PIM-SM ==> create_proc_ipclone() form DEV.c ip_conntrack version 2.1 (512 buckets, 1024 max) - 384 bytes per conntrack IPSEC netfilter connection tracking: registered IPSEC netfilter NAT helper: NETDETECT target register ip_nat_bnet: Trying to register for port 6112 FTP proc OK.... ip_ct_ftp: registering helper for port 21 ip_ct_ftp: # of port 1 ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Ethernet Bridge 008 for NET4.0 VFS: Mounted root (squashfs filesystem) readonly. Freeing unused kernel memory: 60k freed mount /proc file system ok! mount /tmp file system ok! ---> /sbin/init doing alias:w311ar version:8.76 Restore Config ( 4334 bytes ) etc/wireless.conf.wps.wlan0 etc/wireless.conf.wlan0 etc/udhcpd.leases etc/udhcpd.conf etc/services etc/resolv.conf etc/pptpd.conf etc/ppp etc/ppp/options.pptpd etc/passwd etc/miniupnpd.conf etc/mime.types etc/messages etc/ippool.set etc/ippool.conf etc/igmpproxy.conf etc/iconfig.cfg etc/httpd.passwd etc/hosts etc/group etc/fwsched_netfilter.set etc/fwsched.set etc/defaultip Set WAN PORT ================================================================= press magic key to change default setting ... LAN MAC : 00:1D:1A:13:E9:28 WAN MAC : 00:1D:1A:13:E9:29 Bridge Init device wlan0-va0 is not a slave of br0 device wlan0-va1 is not a slave of br0 device wlan0-va2 is not a slave of br0 Interface doesn't accept private ioctl... set_mib (89F1): Operation not permitted iptables: Bad rule (does a matching rule exist in that chain?) iptables: No chain/target/match by that name Jan 1 00:00:11 miniupnpd[197]: Reloading rules from lease file Jan 1 00:00:11 miniupnpd[197]: could not open lease file: /var/run/upnp_pmlist Jan 1 00:00:11 miniupnpd[197]: HTTP listening on port 2048 PPTP Server Start!! insmod: not found killall: iapp: no process killed killall: wscd: no process killed killall: iwcontrol: no process killed SIGNAL -> Config Update signal progress Check DHCP PID Elapsed Time: 1 killall: pppoe-relay: no process killed SIGNAL -> WAN ip changed Reaped 223 Reaped 212 Reaped 196 Reaped 195 iptables: Bad rule (does a matching rule exist in that chain?)

To enter into the bootloader failsafe CLI press the ESC key when booting up the device.

Booting...
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@
@ chip__no chip__id mfr___id dev___id cap___id size_sft dev_size chipSize
@ 0000000h 0c84015h 00000c8h 0000040h 0000015h 0000000h 0000015h 0200000h
@ blk_size blk__cnt sec_size sec__cnt pageSize page_cnt chip_clk chipName
@ 0010000h 0000020h 0001000h 0000200h 0000100h 0000010h 000004eh GD25Q16
@ 
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
 
---RealTek(RTL8196E)at 2012.07.06-04:36+0900 v0.4 [16bit](400MHz)
Delay 1 second till reset button
Magic Number: ����nv 00000000
Check Firmware(05020000) : size: 0x001c3fc8 ---->[ OK ]

---Escape booting by user
P0phymode=01, embedded phy

---Ethernet init Okay!
<RealTek>
Unknown command !
<RealTek>?
----------------- COMMAND MODE HELP ------------------
HELP (?)                                    : Print this help message
DB <Address> <Len>
DW <Address> <Len>
EB <Address> <Value1> <Value2>...
EW <Address> <Value1> <Value2>...
CMP: CMP <dst><src><length>
IPCONFIG:<TargetAddress>
AUTOBURN: 0/1
LOADADDR: <Load Address>
J: Jump to <TargetAddress>
FLR: FLR <dst><src><length>
FLW <dst_ROM_offset><src_RAM_addr><length_Byte> <SPI cnt#>: Write offset-data to SPI from RAM
MDIOR:  MDIOR <phyid> <reg>
MDIOW:  MDIOW <phyid> <reg> <data>
PHYR: PHYR <PHYID><reg>
PHYW: PHYW <PHYID><reg><data>
PORT1: port 1 patch for FT2
<RealTek>