You do not need an accout to report a problem with the wiki.
-
Netgear WNR834Bv2/Serial info
From TechInfoDepot
Jump to navigationJump to searchInfo derived from
boot log |
---|
Decompressing..........done Decompressing..........done CFE version 1.0.37 for BCM947XX (32bit,SP,LE) Build Date: Thu May 3 14:43:11 CST 2007 Copyright (C) 2000,2001,2002,2003 Broadcom Corporation. Initializing Arena Initializing Devices. Boot partition size = 131072(0x20000) et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.80.53.0 et1: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.80.53.0 CPU type 0x29006: 264MHz Total memory: 16384 KBytes Device eth0: hwaddr 00-24-B2-00-89-60, ipaddr 192.168.1.1, mask 255.255.255.0 gateway not set, nameserver not set CPU revision is: 00029006 Primary instruction cache 16kb, linesize 16 bytes (2 ways) Primary data cache 16kb, linesize 16 bytes (2 ways) Linux version 2.4.20 (aspen@coolteam.cs) (gcc version 3.2.3 with Broadcom modifications) #2 Thu Mar 27 15:12:04 CST 2008 Setting the PFC to its default value Determined physical RAM map: memory: 01000000 @ 00000000 (usable) On node 0 totalpages: 4096 zone(0): 4096 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200 CPU: BCM4704 rev 9 at 264 MHz Calibrating delay loop... 263.78 BogoMIPS Memory: 14360k/16384k available (1361k kernel code, 2024k reserved, 108k data, 56k init, 0k highmem) Dentry cache hash table entries: 2048 (order: 2, 16384 bytes) Inode cache hash table entries: 1024 (order: 1, 8192 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 4096 (order: 2, 16384 bytes) Checking for 'wait' instruction... unavailable. POSIX conformance testing by UNIFIX PCI: Initializing host PCI: Enabling CardBus PCI: Fixing up bus 0 PCI: Fixing up bridge PCI: Fixing up bus 1 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 Squashfs 2.2-r2 (released 2005/09/08) (C) 2002-2005 Phillip Lougher Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0xb8000300 (irq = 3) is a 16550A ttyS01 at 0xb8000400 (irq = 0) is a 16550A PPP generic driver version 2.4.2 Amd/Fujitsu Extended Query Table v1.1 at 0x0040 number of CFI chips: 1 Flash device: 0x400000 at 0x1c000000 Physically mapped flash: squashfs filesystem found at block 620 Creating 8 MTD partitions on "Physically mapped flash": 0x00000000-0x00020000 : "boot" 0x00020000-0x003b0000 : "linux" 0x0009b324-0x003b0000 : "rootfs" 0x003b0000-0x003c0000 : "T_Meter1" 0x003c0000-0x003d0000 : "T_Meter2" 0x003d0000-0x003e0000 : "POT" 0x003e0000-0x003f0000 : "board_data" 0x003f0000-0x00400000 : "nvram" NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 2048) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Ethernet Bridge 008 for NET4.0 802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> VFS: Mounted root (squashfs filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 56k freed Algorithmics/MIPS FPU Emulator v1.5 Reading board data... WSC UUID: 0x8062e454105b992f3427e1eda53bf588 Using /lib/modules/2.4.20/kernel/drivers/net/et/et.o insmod: bcm57xx.o: no module by that name found Using /lib/modules/2.4.20/kernel/drivers/net/wl/wl.o Hit enter to continue...NVRAM upgrade required. Starting. NVRAM upgrade complete. Reading board data... WSC UUID: 0x8062e454105b992f3427e1eda53bf588 WARNING: console log level set to 1 eth2: Numerical result out of range eth2: Operation not supported eth2: Invalid argument eth2: Invalid argument eth2: Operation not supported eth2: Operation not supported eth2: Invalid argument eth3: No such device ifconfig: Illegal seek eth4: No such device ifconfig: Illegal seek eth2: ignore i/f due to error(s) ********************************************* Wi-Fi Simple Config Application - Intel Corp. Version: Build 1.0.5, November 19 2006 ********************************************* Reading board data... WSC UUID: 0x8062e454105b992f3427e1eda53bf588 Using /lib/modules/2.4.20/kernel/net/ipv4/acos_nat/acos_nat.o Info: No FWPT default policies. info, udhcp server (v0.9.8) started error, unable to parse 'option wins ' error, unable to parse 'option domain ' POT integrity check OK. POT time is up. Initializing stack...button monitor start...! apLockDownLog_init, counttion = 300, duration = 300! OK Now starting stack get mac = 00 24 B2 00 89 60 Start DHCP client daemon info, udhcp client (v0.9.8) started eth1: No such process Hit enter to continue...DEVICE PIN: 75885960 ******* MODE: Access Point ******* DEVICE PIN:75885960 WSC: In unconfiged AP mode, wait for start command.... tlvPtrChar* : func CMasterControl_InitiateRegistration line 656 allocating memory 0x10004100 for 0x100040e8 Waiting for Registrar to connect... |