Keenetic Starter (KN-1111)/Serial info

Bootlog (KN-1111_stable_3.03.C.12.0-0 version firmware 2020-02-28) • >>

U-Boot 1.1.3 [4.0.0.4-10] (Nov 22 2017 - 08:09:11) Board: Ralink APSoC DRAM: 64 MB relocate_code Pointer at: 83fb0000 ****************************** Software System Reset Occurred ****************************** MediaTek SPI BBU flash driver, SPI clock: 32MHz flash manufacture id: c2, device id 20 19 find flash: MX25L25635E *** Warning - bad CRC, using default environment ============================================ Ralink UBoot Version: 4.0.0.4_NDMS -------------------------------------------- ASIC 7628_MP (Port5<->None) DRAM component: 512 Mbits DDR, width 16 DRAM bus: 16 bit Total memory: 64 MBytes Flash component: SPI Flash Date:Nov 22 2017 Time:08:09:11 ============================================ icache: sets:512, ways:4, linesz:32, total:65536 dcache: sets:256, ways:4, linesz:32, total:32768 ##### The CPU freq = 580 MHZ #### estimate memory size = 64 Mbytes Resetting MT7628 PHY... Dual image: on Boot active: 1 Boot backup: 1 Boot fails: 0 Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Enter boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 0 3: System Boot system code via Flash. ## Booting image at bc050000 ... Image Name: KN-1111 Created: 2020-02-28 5:53:00 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 1318491 Bytes = 1.3 MB Load Address: 80000000 Entry Point: 802f8f84 Verifying Checksum ... OK Uncompressing Kernel Image ... OK No initrd ## Transferring control to Linux (at address 802f8f84) ... ## Giving linux memsize in MB, 64 Starting kernel ... LINUX started... Linux version version 4.9-ndm-4 (developers@ndmsystems.com) (gcc version 8.3.0 (crosstool-NG 1.24.0-rc2-ndm-7 - NDMS Toolkit 1.0.0) ) #2 Thu Feb 20 20:33:17 MSK 2020 MediaTek SoC: MT7628A, RevID: 0102, RAM: DDR2, XTAL: 40MHz CPU/OCP/SYS frequency: 580/193/193 MHz SoC power status: Hard reset occured CPU0 revision is: 00019655 (MIPS 24KEc) Determined physical RAM map: memory: 04000000 @ 00000000 (usable) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes Zone ranges: Normal [mem 0x0000000000000000-0x0000000003ffffff] Movable zone start for each node Early memory node ranges node 0: [mem 0x0000000000000000-0x0000000003ffffff] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 Kernel command line: console=ttyS0,115200n8 PID hash table entries: 256 (order: -2, 1024 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Writing ErrCtl register=00030d40 Readback ErrCtl register=00030d40 Memory: 60856K/65536K available (3036K kernel code, 124K rwdata, 572K rodata, 196K init, 83K bss, 4680K reserved, 0K cma-reserved) NR_IRQS:40 Setting up vectored interrupts clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns console [ttyS0] enabled Calibrating delay loop... 385.02 BogoMIPS (lpj=770048) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 7645041785100000 ns futex hash table entries: 256 (order: -1, 3072 bytes) NET: Registered protocol family 16 clocksource: Switched to clocksource MIPS NET: Registered protocol family 2 TCP established hash table entries: 2048 (order: 1, 8192 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 Load Ralink WDG Timer Module workingset: timestamp_bits=29 max_order=14 bucket_order=0 squashfs: version 4.0 (2009/01/31) Phillip Lougher io scheduler noop registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x10000c00 (irq = 28, base_baud = 2500000) is a 16550A Registering NDM partitions parser MediaTek BBU SPI flash driver, SPI clock: 32MHz SPI flash chip: MX25L25635F (c2 2019c220) (32768 Kbytes) di: active = 1, backup = 1, current = 1 14 ndmpart partitions found on MTD device raspi Creating 14 MTD partitions on "raspi": 0x000000000000-0x000000030000 : "U-Boot" 0x000000030000-0x000000040000 : "U-Config" 0x000000040000-0x000000050000 : "RF-EEPROM" 0x000000050000-0x0000001b0000 : "Kernel_1" 0x0000001b0000-0x000000fb0000 : "RootFS_1" mtd: device 4 (RootFS_1) set to be root filesystem 0x000000050000-0x000000fb0000 : "Firmware_1" 0x000000fb0000-0x000000ff0000 : "Config_1" 0x000000ff0000-0x000001000000 : "Dump" 0x000001000000-0x000001030000 : "U-State" 0x000001030000-0x000001040000 : "U-Config_res" 0x000001040000-0x000001050000 : "RF-EEPROM_res" 0x000001050000-0x000001fb0000 : "Firmware_2" 0x000001fb0000-0x000001ff0000 : "Config_2" 0x000000000000-0x000002000000 : "Full" tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com> PPP generic driver version 2.4.2 PPP MPPE Compression module registered NET: Registered protocol family 24 PPTP driver version 0.8.5 Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (8192 buckets, 32768 max) ctnetlink v0.93: registering with nfnetlink. Fast NAT loaded ip_set: protocol 6 ipip: IPv4 and MPLS over IPv4 tunneling driver gre: GRE over IPv4 demultiplexor driver ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 10 ip6_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 17 ubridge: Tiny bridge driver, 1.2 8021q: 802.1Q VLAN Support v1.8 VFS: Mounted root (squashfs filesystem) readonly on device 31:4. Freeing unused kernel memory: 196K This architecture does not have kernel memory protection. RNG reseed started random: crng init done RNG reseeded init: init process was started. init: press Enter to activate this console. [I] Jan 1 00:00:03 ndm: Core::Main: *** [I] Jan 1 00:00:03 ndm: Core::Main: *** Network Device Manager 3.03.C.12.0-0. [I] Jan 1 00:00:03 ndm: Core::Main: *** Built Feb 20 2020 20:26:16. [I] Jan 1 00:00:03 ndm: Core::Main: *** [I] Jan 1 00:00:04 ndm: Core::System::Mtd::Table: current firmware image index is 1. [I] Jan 1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/nf_nat_proto_gre.ko. [I] Jan 1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/crypto_null.ko. [I] Jan 1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/udp_tunnel.ko. [I] Jan 1 00:00:04 ndm: Core::System::DriverManager: loading /lib/modules/4.9-ndm-4/ip_gre.ko.