Dell TrueMobile 2300 v2 (WRTB-107GD)/Serial info
From TechInfoDepot
Jump to navigationJump to searchTomato 1.28 dmesg |
---|
# dmesg CPU revision is: 00029007 Primary instruction cache 8kb, linesize 16 bytes (2 ways) Primary data cache 4kb, linesize 16 bytes (2 ways) Linux version 2.4.20 (root@tobu) (gcc version 3.2.3 with Broadcom modifications) #1 Sun Jun 27 20:13:35 PDT 2010 Setting the PFC value as 0x15 Determined physical RAM map: memory: 01000000 @ 00000000 (usable) On node 0 totalpages: 4096 zone(0): 4096 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200 CPU: BCM4712 rev 1 at 200 MHz Calibrating delay loop... 199.47 BogoMIPS Memory: 14464k/16384k available (1336k kernel code, 1920k reserved, 108k data, 64k init, 0k highmem) Dentry cache hash table entries: 2048 (order: 2, 16384 bytes) Inode cache hash table entries: 1024 (order: 1, 8192 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 4096 (order: 2, 16384 bytes) Checking for 'wait' instruction... unavailable. POSIX conformance testing by UNIFIX PCI: Disabled PCI: Fixing up bus 0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 squashfs: version 3.0 (2006/03/15) Phillip Lougher pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0xb8000300 (irq = 3) is a 16550A ttyS01 at 0xb8000400 (irq = 0) is a 16550A HDLC line discipline: version $Revision: 1.1.1.4 $, maxframe=4096 N_HDLC line discipline registered. PPP generic driver version 2.4.2 Physically mapped flash: Found an alias at 0x400000 for the chip at 0x0 Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0 Physically mapped flash: Found an alias at 0xc00000 for the chip at 0x0 Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0 Physically mapped flash: Found an alias at 0x1400000 for the chip at 0x0 Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0 Physically mapped flash: Found an alias at 0x1c00000 for the chip at 0x0 number of CFI chips: 1 0: offset=0x0,size=0x20000,blocks=32 Flash device: 0x400000 at 0x1c000000 Creating 5 MTD partitions on "Physically mapped flash": 0x00000000-0x00040000 : "pmon" 0x00040000-0x003e0000 : "linux" 0x000e2a10-0x00300000 : "rootfs" 0x00300000-0x003e0000 : "jffs2" 0x003e0000-0x00400000 : "nvram" sflash: found no supported devices NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 2048) Linux IP multicast router 0.06 plus PIM-SM ip_conntrack version 2.1 (8092 buckets, 4096 max) - 368 bytes per conntrack ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Ethernet Bridge 008 for NET4.0 802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> VFS: Mounted root (squashfs filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 64k freed Algorithmics/MIPS FPU Emulator v1.5 ip_conntrack_pptp version 1.9 loaded ip_nat_pptp version 1.5 loaded ip_conntrack_rtsp v0.01 loading ip_nat_rtsp v0.01 loading eth0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 3.90.38.0 eth1: Broadcom BCM4320 802.11 Wireless Controller 3.90.38.0 tomato_ct.c [Jun 27 2010 20:15:22] vlan0: dev_set_promiscuity(master, 1) device eth0 entered promiscuous mode device vlan0 entered promiscuous mode device eth1 entered promiscuous mode br0: port 2(eth1) entering listening state br0: port 1(vlan0) entering listening state br0: port 2(eth1) entering learning state br0: port 1(vlan0) entering learning state vlan1: Setting MAC address to 00 90 4b 3b 07 f9. br0: port 2(eth1) entering forwarding state br0: topology change detected, propagating br0: port 1(vlan0) entering forwarding state br0: topology change detected, propagating vlan1: add 01:00:5e:00:00:01 mcast address to master interface |