CSR CSR6030

Known revisions

• CSR6030 A10 AU - STA only?
• CSR6030 A11 AU - STA + AP modes

Details

Radio

• On-chip baluns for single-ended RF input and output
• No external trimming required in production
• Low output spurii and strong receive blocking performance against cellular bands

allows for good coexistence with cellular radios

• Front-end control logic can be programmed to support common 802.11 only and 802.11

+ Bluetooth RF front-end configurations

• Support for antenna diversity selection

Transmitter

• Support for power compensation of external PA to produce stable transmit power across temperature
• Digital predistortion can be used to compensate for non-linearities in external PA
• Control of transmit gain settings on a per-packet basis allows transmit power to be optimised

for each modulation scheme

Receiver

• Fast AGC and wide dynamic range allow for excellent robustness against fading

Frequency Synthesiser

• Fully integrated fractional-N synthesiser
• Low phase noise and fast switching time
• Supports all 802.11b/g/n (20MHz) channel frequencies

Frequency Reference

• Support for common cellular reference frequencies
• On-chip crystal driver
• Digital trimming of crystal enables use of less tightly toleranced crystals
• Internal low-power clock eliminates requirement for an additional frequency reference

Auxiliary Features

• Four 10-bit ADCs/DACs used for internal calibration. These can also be used to provide

a bias voltage or measure the output power of an external PA.

Modem

• Supports the following modulations:

1. All mandatory 802.11b modulations: 1, 2, 5.5, 11Mbps
2. All 802.11g OFDM modulations: 6, 9, 12, 18, 24, 36, 48, 54Mbps
3. 802.11n HT modulations MCS0-7, 20MHz, 800 and 400ns guard interval:
   

6.5, 7.2, 13.0, 14.4, 19.5, 21.7, 26.0, 28.9, 39.0, 43.3, 52.0, 57.8, 58.5, 65.0, 72.2Mbps

1. STBC reception for 802.11n HT modulations MCS0-7

• Dynamic power saving

MAC

• Comprehensive MAC functionality according to 802.11-2007, including QoS traffic scheduling
• Supports the following optional 802.11n features:

1. MPDU aggregation
2. MSDU aggregation
3. Immediate Block Acknowledgement
4. PSMP
5. MTBA
6. RIFS
7. L-SIG TXOP protection
8. Link adaptation using MCS feedback

Encryption

• Hardware encryption according to 802.11-2007 and 802.11w-2009:

1. WEP40/64
2. WEP104/128
3. CCMP (AES)
4. TKIP
5. BIP

• Hardware encryption support for SMS4 to support WAPI (requires WAPI add-on host side software)
• Hardware encryption support for Cisco ® CKIP

Supplies

• Integrated LDOs for all core (1.2V) supplies

Package Options

• 56 Lead 8 x 8 x 0.9mm, 0.5mm pitch QFN