
You do not need an accout to report a problem with the wiki.
-
Buffalo WHR-HP-G54
From TechInfoDepot
(Redirected from Buffalo WHR-HP-G54-DD)
Jump to navigationJump to searchbg (G54) | |
---|---|
Wireless-G High Power Router and Access Point | |
![]() | |
Wikipedia | |
InfoDepot Wiki | |
WikiDevi.wi-cat.ru | |
3rd Party Firmware | |
dd-wrt | |
OpenWrt | |
Tomato any flavor | |
Gargoyle |
Status Unknown |
Platform | |
Brand • Model • Rev |
Buffalo WHR-HP-G54 |
FCC ID | |
IC ID | |
Type |
wireless router |
CPU1 ![]() | |
CPU1 Type |
BMIPS3300 |
CPU1 Speed |
200 MHz |
Flash1 Chip |
Winbond W19B320ABT7H |
Flash1 Size |
4 MiB4,194,304 B <br />32,768 Kib <br />4,096 KiB <br />32 Mib <br />0.00391 GiB <br /> |
RAM1 Size |
16 MiB16,777,216 B <br />131,072 Kib <br />16,384 KiB <br />128 Mib <br />0.0156 GiB <br /> |
RAM1 Chip |
Mira P2V64S40ETP-G6 x 2 |
ETH chip1 | |
Switch | |
Ethernet Port Count |
1-100MbE-WAN 4-100MbE-LAN |
Wired Standard |
IEEE 802.3i/3u |
Stock bootloader |
CFE 1.0.37-1.08 BCM947XX |
Stock FW OS |
Linux |
Expansion IF types |
none specified |
Power |
5 VDC, 1.3 A |
Connector type |
barrel |
Serial Port (UART) |
yes |
Flags: high power | |
Additional chips | |
Other | |
Default SSID: 000D0BXXXXXX (3 addl. devices) | |
3rd Party Firmware Support | |
Retail | |
Availability | End of Life |
FCC approval date | 06 August 2005 |
UPC |
747464109695 (UPC DB, On eBay) |
ASIN |
B000AOKTJ8 ![]() |
Country of manuf | Taiwan |
Radio 1 | |
Chip1 | |
Chip2 |
Broadcom BCM2050 |
Wireless interface OUI |
00:0D:0B, 00:16:01 |
Antenna Connector Type |
RP-SMA |
Wireless Standard |
IEEE 802.11b/g |
802.11g |
up to 54 Mbps |
802.11b |
up to 11 Mbps |
WiFi Operating Frequency |
2.4 GHz |
Radio cor_rev |
9 |
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
For a list of all currently documented Buffalo device with specifications, see Buffalo.
- • 54 Mbps - 2.4GHz 802.11g = G54 class
Overview
Multiple revisions?
- "BCM5352-HP-EA" is silkscreened on the board in the TechInfoDepot pictures.
- "BCM5352-HP-DA" is silkscreened on the board in the FCC photos.
This device is using an Anadigics AWL6153 Power Amplifier Module.
Links of Interest
Wikis
- On the OpenWrt Wiki
- Like most low-spec b/g BCM47xx gear, using Backfire (10.03.1) would be recommended
- On the DD-WRT Wiki
Spec. sites
- If the Whirlpool data is accurate, the default SSID is the wireless interface MAC address. WiGLE data shows the XX:XX:XX:XX:XX:XX pattern described in the Whirlpool data to be somewhat less common than XXXXXXXXXXXX.
Flashing
![]() | NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing dd-wrt
Support started version: v24 std (05/24/08) - build 9526
Current supported version: unknown
Comment:
initial flash: use Tftp flash
Current supported version: unknown
Comment:
initial flash: use Tftp flash
Flashing OpenWrt
![]() | This device is NO LONGER SUPPOTED OR POSSIBLE for future use with OpenWrt. |
On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki
OpenWrt Target: brcm47xx
OpenWrt Subtarget: legacy
OpenWrt Package architecture: mipsel_mips32
Support started version: 7.09
Current supported version: EOL
Last Supported Version: 10.03.1
On the OpenWrt Wiki
OpenWrt Target: brcm47xx
OpenWrt Subtarget: legacy
OpenWrt Package architecture: mipsel_mips32
Support started version: 7.09
Current supported version: EOL
Last Supported Version: 10.03.1
Please insert instructions here
Flashing Tomato
Please insert instructions here
JTAG-Serial Info
Serial
Serial Pinouts
(3.3) (GND) (TxD) (RxD) J1 <---- board edge ----> to Flash
Pictures
Categories:
- Buffalo
- Embedded system/wireless router
- Embedded System Broadcom
- Embedded System BCM5352E
- Broadcom
- Embedded System BMIPS3300
- Embedded System
- DD-WRT Supported
- OpenWrt Was Supported
- Tomato Supported
- Embedded System BCM2050
- Embedded System IEEE 802.11b/g
- Single-Radio Wireless Embedded System
- Wireless Embedded System
- FCC Photo's Needed