Belkin F9K1015 v1/Serial info

Boot Log

Booting... @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @ @ chip__no chip__id mfr___id dev___id cap___id size_sft dev_size chipSize @ 0000000h 0c22016h 00000c2h 0000020h 0000016h 0000000h 0000016h 0400000h @ blk_size blk__cnt sec_size sec__cnt pageSize page_cnt chip_clk chipName @ 0010000h 0000040h 0001000h 0000400h 0000100h 0000010h 0000027h MX25L3205D @ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ ---RealTek(RTL8196E)at 2013.11.21-12:29+0800 v1.2 [16bit](380MHz) no rootfs signature at 000E0000! no rootfs signature at 000B0000! no rootfs signature at 000F0000! Jump to image start=0x80500000... decompressing kernel: Uncompressing Linux... done, booting the kernel. done decompressing kernel. start address: 0x80003480 CPU revision is: 0000cd01 Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Zone PFN ranges: Normal 0x00000000 -> 0x00002000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00002000 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: console=ttyS0,38400 root=/dev/mtdblock1 icache: 16kB/16B, dcache: 8kB/16B, scache: 0kB/0B NR_IRQS:48 PID hash table entries: 128 (order: 7, 512 bytes) console handover: boot [early0] -> real [ttyS0] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 26532k/32768k available (2302k kernel code, 6236k reserved, 511k data, 96k init, 0k highmem) Calibrating delay loop... 379.28 BogoMIPS (lpj=1896448) Mount-cache hash table entries: 512 net_namespace: 324 bytes NET: Registered protocol family 16 bio: create slab <bio-0> at 0 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered NET: Registered protocol family 1 squashfs: version 4.0 (2009/01/31) Phillip Lougher msgmni has been set to 51 io scheduler noop registered io scheduler cfq registered (default) Realtek GPIO Driver for Flash Reload Default Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x18002000 (irq = 8) is a 16550A Realtek WLAN driver - version 1.6 (2013-02-21) Adaptivity function - version 7.1 wlan_index:0 0, 6,0xb9000000,0xb8b10000,11 =====>>INSIDE rtl8192cd_init_one <<===== PCIE reset (0) Do MDIO_RESET Find Port=0 Device:Vendor ID=818b10ec vendor_deivce_id=818b10ec HalAssociateNic OK ####################################################### SKB_BUF_SIZE=2408 MAX_SKB_NUM=400 ####################################################### =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] =====>>INSIDE rtl8192cd_init_one <<===== =====>>EXIT rtl8192cd_init_one <<===== <rtl8192cd_init_one>LZQ: after read tmpReg[0x1c] Probing RTL8186 10/100 NIC-kenel stack size order[3]... chip name: 8196C, chip revid: 0 NOT YET eth0 added. vid=9 Member port 0x10... eth1 added. vid=8 Member port 0x0... eth2 added. vid=9 Member port 0x2... eth3 added. vid=9 Member port 0x4... eth4 added. vid=9 Member port 0x8... [peth0] added, mapping to [eth1]... SPI INIT ------------------------- Force into Single IO Mode ------------------------ |No chipID Sft chipSize blkSize secSize pageSize sdCk opCk chipName | | 0 c22016h 0h 400000h 10000h 1000h 100h 50 0 MX25L3206E| ---------------------------------------------------------------------------- SPI flash (MX25L3206E) was found at CS0, size 0x400000 Creating 2 MTD partitions on "flash_bank_1": 0x000000000000-0x000000400000 : "boot+cfg+linux" 0x000000130000-0x000000400000 : "root fs" TCP cubic registered NET: Registered protocol family 17 dnshijack VFS: Mounted root (squashfs filesystem) readonly on device 31:1. Freeing unused kernel memory: 96k freed init started: BusyBox v1.11.1 (2015-02-11 11:42:19 CST) starting pid 13, tty '': '/etc/init.d/rcS' Please press Enter to activate this console. starting pid 15, tty '': '-/bin/sh' BusyBox v1.11.1 (2015-02-11 11:42:19 CST) built-in shell (ash) Enter 'help' for a list of built-in commands. ifconfig: ioctl 0x8913 failed: No such device bridge br0 doesn't exist; can't delete it ifconfig: ioctl 0x8913 failed: No such device bridge br2 doesn't exist; can't delete it InitPON OK InitMAC OK InitHCIDMAReg OK phy_BB88XX_Config_ParaFile(6227), HAL PHY_ConfigBBWithParaFile [PHY_ConfigBBWithParaFile][PHY_REG_HAL] [PHY_ConfigBBWithParaFile][PHY_REG_PG_HAL] [PHY_ConfigBBWithParaFile][AGC_TAB_HAL] [phy_RF6052_Config_ParaFile][RadioA_HAL] [phy_RF6052_Config_ParaFile][RadioB_HAL] InitDownload FW OK [PHY_ConfigTXPwrTrackingWithParaFile][REG_TXPWR_TRK_8192E] 8192E LCK done!! wlan_scan command: wlan0 scanssid I Love Pilastra Use VXD for repeater mode, Disable TXBF StopHW Succeed InitPON OK InitMAC OK InitHCIDMAReg OK phy_BB88XX_Config_ParaFile(6227), HAL PHY_ConfigBBWithParaFile [PHY_ConfigBBWithParaFile][PHY_REG_HAL] [PHY_ConfigBBWithParaFile][PHY_REG_PG_HAL] [PHY_ConfigBBWithParaFile][AGC_TAB_HAL] [phy_RF6052_Config_ParaFile][RadioA_HAL] [phy_RF6052_Config_ParaFile][RadioB_HAL] InitDownload FW OK [PHY_ConfigTXPwrTrackingWithParaFile][REG_TXPWR_TRK_8192E] 8192E LCK done!! device eth0 entered promiscuous mode device wlan0 entered promiscuous mode device wlan0-vxd entered promiscuous mode br0: port 3(wlan0-vxd) entering forwarding state br0: port 2(wlan0) entering forwarding state br0: port 1(eth0) entering forwarding state dns_hijack_enabled = 1 udhcpc (v1.11.1) started MemFree: 19692 kB addcgiext .lua,.lp,.php axhttpd/1.4.9: listening on ports 80 (http) and 443 (https) boa: server version Boa/0.94.14rc21 boa: server built Feb 11 2015 at 11:41:55. boa: starting server pid=289, port 80 # Notice: caching turned off