Banana Pi BPI Pro
From TechInfoDepot
Jump to navigationJump to searchbgn (N150) | |||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Development Board | |||||||||||||||||||||||||
WikiDevi.wi-cat.ru | |||||||||||||||||||||||||
3rd Party Firmware | |||||||||||||||||||||||||
dd-wrt |
Status Unknown | ||||||||||||||||||||||||
OpenWrt | |||||||||||||||||||||||||
Tomato any flavor |
Incompatible | ||||||||||||||||||||||||
Gargoyle |
Status Unknown | ||||||||||||||||||||||||
Platform | |||||||||||||||||||||||||
Brand • Model • Rev |
Banana Pi BPIPro | ||||||||||||||||||||||||
FCC ID | |||||||||||||||||||||||||
Type |
single-board computer | ||||||||||||||||||||||||
CPU1 | |||||||||||||||||||||||||
CPU1 Type |
ARM Cortex-A7 (v7-A) | ||||||||||||||||||||||||
CPU1 Speed |
1.0 GHz ( 2 cores ) | ||||||||||||||||||||||||
Flash1 Chip |
Brand? Model? | ||||||||||||||||||||||||
Flash1 Size |
0 MiB0 B <br />0 Kib <br />0 KiB <br />0 Mib <br />0 GiB <br /> (MicroSD) | ||||||||||||||||||||||||
RAM1 Size |
1 GiB 1,024 MiB <br />1,073,741,824 B <br />8,388,608 Kib <br />1,048,576 KiB <br />8,192 Mib <br /> | ||||||||||||||||||||||||
RAM1 Chip |
SK hynix H5TQ4G63AFR-PBC x 2 | ||||||||||||||||||||||||
ETH chip1 |
Realtek RTL8211E | ||||||||||||||||||||||||
Ethernet Port Count |
1-1GbE-LAN | ||||||||||||||||||||||||
Wired Standard |
IEEE 802.3i/3u/3ab | ||||||||||||||||||||||||
802dot11 OUI: none specified | |||||||||||||||||||||||||
Expansion IF types |
USB 2.0, SATA, MicroSD Card slot | ||||||||||||||||||||||||
USB ports |
2 | ||||||||||||||||||||||||
SD/MMC Slots |
1 | ||||||||||||||||||||||||
SATA Ports |
1 | ||||||||||||||||||||||||
USB Hub Compatible |
Untested | ||||||||||||||||||||||||
Power |
5 VDC, 2 A | ||||||||||||||||||||||||
Connector type |
USB Female Micro-B | ||||||||||||||||||||||||
Serial Port (UART) |
yes, 3-pin header, 3.3V TTL, (115200 8N1) | ||||||||||||||||||||||||
Flags: IrDA, HDMI, A/V out (3.5mm), easily accessible GPIO | |||||||||||||||||||||||||
Other | |||||||||||||||||||||||||
| |||||||||||||||||||||||||
Manuf/OEM/ODM |
LeMaker | ||||||||||||||||||||||||
3rd Party Firmware Support | |||||||||||||||||||||||||
Retail | |||||||||||||||||||||||||
(Est.) release date | October 2014 | ||||||||||||||||||||||||
ASIN | B01GA447JE | ||||||||||||||||||||||||
Country of manuf | China | ||||||||||||||||||||||||
Radio 1 | |||||||||||||||||||||||||
Radio1 module | |||||||||||||||||||||||||
Radio1 module IF |
SDIO | ||||||||||||||||||||||||
Chip1 |
Broadcom BCM43362 | ||||||||||||||||||||||||
Wireless interface OUI |
none specified | ||||||||||||||||||||||||
Antenna Connector Type |
U.FL | ||||||||||||||||||||||||
MIMO status |
1x1:1 | ||||||||||||||||||||||||
Wireless Standard |
IEEE 802.11b/g/n | ||||||||||||||||||||||||
802.11n |
up to 150 Mbps | ||||||||||||||||||||||||
802.11g |
up to 54 Mbps | ||||||||||||||||||||||||
802.11b |
up to 11 Mbps | ||||||||||||||||||||||||
WiFi Operating Frequency |
2.4 GHz | ||||||||||||||||||||||||
|
For a list of all currently documented Allwinner SoC's with specifications, see Allwinner.
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
For a list of all currently documented Realtek chipsets with specifications, see Realtek.
For a list of all currently documented Banana Pi device with specifications, see Banana Pi.
- • 150 Mbps - 1SS 2.4GHz 802.11n (40MHz chan.) = N150 class
Overview
- CPU: Broadcom BCM43362 ARM Cortex-M3 (WICED)
- Wi-Fi: AMPAK AP6181 - 802.11bgn (150Mbps)
- 1x 10/100/1000 Ethernet RJ45 port
Links of Interest
- Product page (LeMaker)
- On LeMaker Wiki
- On SunXi Wiki
Flashing
NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
Devices with Broadcom WiFi chipsets have limited OpenWrt supportability (due to limited FLOSS driver availability for Broadcom chips). Consider this when choosing a device to buy, or when deciding to flash OpenWrt on your device because it is listed as supported. See Broadcom WiFi for details. |
On the OpenWrt ToH (techdata entry)
On the OpenWrt Wiki
OpenWrt Target: sunxi
OpenWrt Subtarget: cortexa7
OpenWrt Package architecture: arm_cortex-a7_neon-vfpv4
Support started version: 15.05
Current supported version: 23.05.5
On the OpenWrt Wiki
OpenWrt Target: sunxi
OpenWrt Subtarget: cortexa7
OpenWrt Package architecture: arm_cortex-a7_neon-vfpv4
Support started version: 15.05
Current supported version: 23.05.5
Please insert instructions here
JTAG-Serial Info
Serial
iw list dump |
---|
Bananian Linux 16.04 / Debian GNU/Linux 8.4 (jessie) linux-image-3.4.111-bananian_16.04.01 (ap6210 op_mode=2) linux-firmware-image_16.04.01 (fw_bcm40181a2.bin Apr 22 2013 14:50:00 version 5.90.195.89.6 FWID 01-b30a427d) Wiphy phy0 Band 1: Capabilities: 0x1020 HT20 Static SM Power Save RX HT20 SGI No RX STBC Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 16 usec (0x07) HT RX MCS rate indexes supported: 0-7 HT TX MCS rate indexes are undefined Frequencies: * 2412 MHz [1] (20.0 dBm) * 2417 MHz [2] (20.0 dBm) * 2422 MHz [3] (20.0 dBm) * 2427 MHz [4] (20.0 dBm) * 2432 MHz [5] (20.0 dBm) * 2437 MHz [6] (20.0 dBm) * 2442 MHz [7] (20.0 dBm) * 2447 MHz [8] (20.0 dBm) * 2452 MHz [9] (20.0 dBm) * 2457 MHz [10] (20.0 dBm) * 2462 MHz [11] (20.0 dBm) * 2467 MHz [12] (20.0 dBm) * 2472 MHz [13] (20.0 dBm) * 2484 MHz [14] (20.0 dBm) Bitrates (non-HT): * 1.0 Mbps * 2.0 Mbps (short preamble supported) * 5.5 Mbps (short preamble supported) * 11.0 Mbps (short preamble supported) * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps max # scan SSIDs: 10 max scan IEs length: 2048 bytes Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Supported Ciphers: * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * TKIP (00-0f-ac:2) * CCMP (00-0f-ac:4) * CMAC (00-0f-ac:6) Available Antennas: TX 0 RX 0 Supported interface modes: * managed * AP * monitor software interface modes (can always be added): interface combinations are not supported Supported commands: * new_interface * set_interface * new_key * start_ap * set_bss * join_ibss * set_pmksa * del_pmksa * flush_pmksa * remain_on_channel * frame * frame_wait_cancel * set_wiphy_netns * set_channel * connect * disconnect Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0xd0 * managed: 0x40 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 |
Categories:
- Banana Pi
- Embedded system/single-board computer
- Embedded System Allwinner
- Embedded System A20
- Allwinner
- Embedded System ARM
- Embedded System Cortex-A7 (v7-A)
- Embedded System Realtek
- Embedded System RTL8211E
- Realtek
- Manuf LeMaker
- OpenWrt Supported
- Embedded System Broadcom
- Embedded System BCM43362
- Broadcom
- Has Mimo Status
- Embedded System IEEE 802.11b/g/n
- Single-Radio Wireless Embedded System
- Wireless Embedded System
- Embedded System
- English Documentation