NXP LS1028ARDB
From TechInfoDepot
Jump to navigationJump to searchSingle Board Computer | |
Homepage | |
---|---|
3rd Party Firmware | |
dd-wrt |
Status Unknown |
OpenWrt | |
Tomato any flavor |
Incompatible |
Gargoyle |
Status Unknown |
Platform | |
Brand • Model • Rev |
NXP LS1028ARDB |
Type |
single-board computer |
CPU1 |
NXP LS1028A |
CPU1 Speed |
1.3 GHz ( 2 cores ) |
Flash1 Chip |
Brand? Model? |
Flash1 Size |
512 MiB536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br /> (NAND) |
Flash2 Size |
256 MiB268,435,456 B <br />2,097,152 Kib <br />262,144 KiB <br />2,048 Mib <br />0.25 GiB <br /> (eMMC) |
RAM1 Size |
4 GiB 4,096 MiB <br />4,294,967,296 B <br />33,554,432 Kib <br />4,194,304 KiB <br />32,768 Mib <br /> |
RAM1 Chip |
Brand? Model? |
ETH chip1 |
NXP LS1028A |
Switch |
NXP LS1028A |
Ethernet Port Count |
1-1GbE-WAN 4-1GbE-LAN |
Wired Standard |
IEEE 802.3i/3u/3ab |
| |
Stock bootloader |
U-Boot |
Expansion IF types |
M.2 Type E slots with PCIe Gen 3.0, USB 3.0, M.2 Type B slot with SATA 3.0 (resistor mux with 1 Type E slot) |
Mini PCIe slots |
1 |
USB ports |
2 |
SATA Ports |
1 |
M.2 Slots |
2 |
USB Hub Compatible |
Untested |
Power |
12 VDC, ? A |
Connector type |
barrel |
Serial Port (UART) |
yes, (115200 8N1) |
JTAG Port |
yes |
Other | |
| |
3rd Party Firmware Support |
For a list of all currently documented NXP (Freescale) SoC's with specifications, see NXP.
For a list of all currently documented NXP device with specifications, see NXP.
Flashing
NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power. |
Flashing OpenWrt
On the OpenWrt ToH (techdata entry)
OpenWrt Target: layerscape
OpenWrt Subtarget: armv8_64b
OpenWrt Package architecture: aarch64_generic
Support started version: 23.05.0
Current supported version: 23.05.5
OpenWrt Target: layerscape
OpenWrt Subtarget: armv8_64b
OpenWrt Package architecture: aarch64_generic
Support started version: 23.05.0
Current supported version: 23.05.5
Please insert instructions here