Serial info

From TechInfoDepot
Jump to navigationJump to search

Info derived from[edit]

boot log
ar531x rev 0x00005742 firmware startup...
SDRAM TEST SKIPPED
Please check the ethernet cable on port 0

Atheros AR5001AP default version 4.0.0.48
Bootloader version 1.01


 0
auto-booting...

Attaching to TFFS... done.
Loading /fl/APIMG1...1073872
Starting at 0x804846e0...

/fl/  - Volume is OK
Reading Configuration File "/fl/apcfg".
Configuration file checksum: 4da56 is good
Please check the ethernet cable on port 0!
Attaching interface lo0...done
vp0 macaddr = 00:12:17:77:41:30
vp65536 macaddr = 00:12:17:77:41:31
ae0 macaddr = 00:12:17:77:41:32
start easy conf
wireless access point starting...
wlan1 Ready
wireless access point starting...
Auto Channel Scan selected 5280 MHz, channel 56
wlan0 Ready
Ready
AP shell help
WAP55AG wlan0 -> ?
List of Access Point CLI commands:
 add remoteWbr                      -- Add a remote Wireless Bridge
 config wlan                        -- config wlanX
 connect bss                        -- connect to bssX
 del acl                            -- Delete Access Control List
 del key                            -- Delete Encryption key
 del remoteWbr                      -- Delete a remote Wireless Bridge
 find bss                           -- Find BSS
 find channel                       -- Find Available Channel
 find all                           -- Find All BSS
 ftp                                -- Software update via FTP
 get acl                            -- Display Access Control List
 get aging                          -- Display Aging Interval
 get antenna                        -- Display Antenna Diversity
 get association                    -- Display Association Table
 get authentication                 -- Display Authentication Type
 get autochannelselect              -- Display Auto Channel Select
 get beaconinterval                 -- Display Beacon Interval
 get burstSeqThreshold              -- Display Max Number of frames in a Burst
 get burstTime                      -- Display Burst Time
 get channel                        -- Display Radio Channel
 get cipher                         -- Display Encryption cipher
 get config                         -- Display Current AP Configuration
 get countrycode                    -- Display Country Code
 get domainsuffix                   -- Display Domain Name Server suffix
 get dtim                           -- Display Data Beacon Rate (DTIM)
 get encryption                     -- Display Encryption Mode
 get fragmentthreshold              -- Display Fragment Threshold
 get frequency                      -- Display Radio Frequency (MHz)
 get gateway                        -- Display Gateway IP Address
 get groupkeyupdate                 -- Display Group Key Update Interval (in Seconds)
 get hardware                       -- Display Hardware Revisions
 get hostipaddr                     -- Display Host IP Address
 get ipaddr                         -- Display IP Address
 get ipmask                         -- Display IP Subnet Mask
 get jsw                            -- Display Jumpstart Mode
 get key                            -- Display Encryption Key
 get keyentrymethod                 -- Display Encyrption Key Entry Method
 get keysource                      -- Display Source Of Encryption Keys
 get login                          -- Display Login User Name
 get minimumrate                    -- Display Minimum Rate
 get nameaddr                       -- Display IP address of name server
 get operationMode                  -- Display Operation Mode
 get pktLogEnable                   -- Display Packet Logging Mode
 get power                          -- Display Transmit Power Setting
 get radiusname                     -- Display RADIUS server name or IP address
 get radiusport                     -- Display RADIUS port number
 get rate                           -- Display Data Rate
 get reg                            -- Display the register contents at the given offset
 get remoteAp                       -- Display Remote Ap's Mac Address
 get remoteWbr                      -- Display configured Remote Wireless bridges
 get rtsthreshold                   -- Display RTS/CTS Threshold
 get sntpserver                     -- Display SNTP/NTP Server IP Address
 get ssid                           -- Display Service Set ID
 get ssidsuppress                   -- Display SSID Suppress Mode
 get station                        -- Display Station Status
 get SuperG                         -- Display SuperG Feature Status
 get systemname                     -- Display Access Point System Name
 get tzone                          -- Display Time Zone Setting
 get upsd                           -- Display UPSD Mode
 get uptime                         -- Display UpTime
 get vlan                           -- Display VLAN Mode
 get wirelessmode                   -- Display Wireless LAN Mode
 get wmm                            -- Display WMM Mode
 get wmmParamBss                    -- Display WMM parameters used by STA in this BSS
 get wmmParam                       -- Display WMM parameters used by this AP
 get wlanstate                      -- Display wlan state
 help                               -- Display CLI Command List
 ping                               -- Ping
 pktLog                             -- Packet Log
 reboot                             -- Reboot Access Point
 run                                -- Run command file
 quit                               -- Logoff
 set acl                            -- Set Access Control List
 set aging                          -- Set Aging Interval
 set antenna                        -- Set Antenna
 set authentication                 -- Set Authentication Type
 set autochannelselect              -- Set Auto Channel Selection
 set beaconinterval                 -- Modify Beacon Interval
 set burstSeqThreshold              -- Set Max Number of frames in a Burst
 set burstTime                      -- Set Burst Time
 set channel                        -- Set Radio Channel
 set cipher                         -- Set Cipher
 set countrycode                    -- Set Country Code
 set domainsuffix                   -- Set Domain Name Server Suffix
 set dtim                           -- Set Data Beacon Rate (DTIM)
 set encryption                     -- Set Encryption Mode
 set factorydefault                 -- Restore to Default Factory Settings
 set fragmentthreshold              -- Set Fragment Threshold
 set frequency                      -- Set Radio Frequency (MHz)
 set gateway                        -- Set Gateway IP Address
 set groupkeyupdate                 -- Set Group Key Update Interval (in Seconds)
 set hostipaddr                     -- Set Host IP address
 set ipaddr                         -- Set IP Address
 set ipmask                         -- Set IP Subnet Mask
 set jsw                            -- Set Jumpstart Mode
 set key                            -- Set Encryption Key
 set keyentrymethod                 -- Select Encryption Key Entry Method
 set keysource                      -- Select Source Of Encryption Keys
 set login                          -- Modify Login User Name
 set minimumrate                    -- Set Minimum Rate
 set nameaddress                    -- Set Name Server IP address
 set operationMode                  -- Set operation Mode
 set password                       -- Modify Password
 set passphrase                     -- Modify Passphrase
 set pktLogEnable                   -- Enable Packet Logging
 set power                          -- Set Transmit Power
 set radiusname                     -- Set RADIUS name or IP address
 set radiusport                     -- Set RADIUS port number
 set radiussecret                   -- Set RADIUS shared secret
 set rate                           -- Set Data Rate
 set reg                            -- Set Register Value
 set remoteAP                       -- Set Remote AP's Mac Address
 set rtsthreshold                   -- Set RTS/CTS Threshold
 set sntpserver                     -- Set SNTP/NTP Server IP Address
 set ssid                           -- Set Service Set ID
 set ssidsuppress                   -- Set SSID Suppress Mode
 set SuperG                         -- Super G Features
 set systemname                     -- Set Access Point System Name
 set tzone                          -- Set Time Zone Setting
 set upsd                           -- Set UPSD Mode
 set vlan                           -- Set VLAN Mode
 set wlanstate                      -- Set wlan state
 set wirelessmode                   -- Set Wireless LAN Mode
 set wmm                            -- Set WMM Mode
 set wmmParamBss                    -- Set WMM parameters used by STAs in this BSS
 set wmmParam                       -- Set WMM parameters used by this AP
 timeofday                          -- Display Current Time of Day
 version                            -- Software version
 nvram                              -- nvram utility
AP shell version + get hardware
WAP55AG wlan0 -> version
AP software 4.0.0.80
mars@MARSNB:E:/AP_4.0.0.80_THGSrc_Src/ap/os/vxworks/target/proj/ap-ar5312-production
Jan 26 2005, 16:54:11

WAP55AG wlan0 -> get hardware
wlan0 revisions: mac 5.7 phy 4.2 analog 3.6
  PCI Vendor ID: 0x168c, Device ID: 0x13
  Sub Vendor ID: 0x168c, Sub Device ID: 0x13
chip is AR5312
nvram show
WAP55AG wlan0 -> nvram show
regulatory_domain=FCC
country_domain=US
wan_proto=static
sys_name=WAP55AG
wan_domain=
lan_ipaddr=192.168.1.246
lan_netmask=255.255.255.0
dhcps_mode=enabled
wan_dns=
login_name=
login_password=admin
lan_gateway=192.168.1.1
wl0_ssid=linksys-a
wl0_channel=0
wl0_stat_mode=enabled
wl0_wirelessmode=11a
wl0_ssid_bcast=enabled
wl0_security_mode=disabled
wl0_encrypt_idx=40
wl0_key_idx=1
wl0_key1=
wl0_key2=
wl0_key3=
wl0_key4=
wl0_cipher_type=tkip
wl0_wpa_passphrase=
wl0_wpa_group_key_interval=1500
wl0_auth_type=open
wl0_transmission_rate=auto
wl0_transmission_power=full
wl0_frame_burst=enabled
wl0_beacon_interval=100
wl0_dtim_interval=1
wl0_frag_threshold=2346
wl0_rts_threshold=2346
wl1_ssid=linksys-g
wl1_channel=6
wl1_stat_mode=enabled
wl1_wirelessmode=11g
wl1_wirelessmode_tmp=11g
wl1_ssid_bcast=enabled
wl1_security_mode=disabled
wl1_encrypt_idx=40
wl1_key_idx=1
wl1_key1=
wl1_key2=
wl1_key3=
wl1_key4=
wl1_cipher_type=tkip
wl1_wpa_passphrase=
wl1_wpa_group_key_interval=1500
wl1_auth_type=open
wl1_basic_rate=default
wl1_transmission_rate=auto
wl1_transmission_power=full
wl1_cts_protection_mode=auto
wl1_frame_burst=enabled
wl1_beacon_interval=100
wl1_dtim_interval=1
wl1_frag_threshold=2346
wl1_rts_threshold=2347
radius_server_ipaddr=0.0.0.0
radius_server_ipaddr_1=0
radius_server_ipaddr_2=0
radius_server_ipaddr_3=0
radius_server_ipaddr_4=0
radius_server_port=1812
radius_shared_key=
radius_shared_key_interval=3600
filter_mode=disabled
filter_type=allow
filter_mac_1=00:00:00:00:00:00
filter_mac_2=00:00:00:00:00:00
filter_mac_3=00:00:00:00:00:00
filter_mac_4=00:00:00:00:00:00
filter_mac_5=00:00:00:00:00:00
filter_mac_6=00:00:00:00:00:00
filter_mac_7=00:00:00:00:00:00
filter_mac_8=00:00:00:00:00:00
filter_mac_9=00:00:00:00:00:00
filter_mac_10=00:00:00:00:00:00
filter_mac_11=00:00:00:00:00:00
filter_mac_12=00:00:00:00:00:00
filter_mac_13=00:00:00:00:00:00
filter_mac_14=00:00:00:00:00:00
filter_mac_15=00:00:00:00:00:00
filter_mac_16=00:00:00:00:00:00
filter_mac_17=00:00:00:00:00:00
filter_mac_18=00:00:00:00:00:00
filter_mac_19=00:00:00:00:00:00
filter_mac_20=00:00:00:00:00:00
filter_mac_21=00:00:00:00:00:00
filter_mac_22=00:00:00:00:00:00
filter_mac_23=00:00:00:00:00:00
filter_mac_24=00:00:00:00:00:00
filter_mac_25=00:00:00:00:00:00
filter_mac_26=00:00:00:00:00:00
filter_mac_27=00:00:00:00:00:00
filter_mac_28=00:00:00:00:00:00
filter_mac_29=00:00:00:00:00:00
filter_mac_30=00:00:00:00:00:00
filter_mac_31=00:00:00:00:00:00
filter_mac_32=00:00:00:00:00:00
filter_mac_33=00:00:00:00:00:00
filter_mac_34=00:00:00:00:00:00
filter_mac_35=00:00:00:00:00:00
filter_mac_36=00:00:00:00:00:00
filter_mac_37=00:00:00:00:00:00
filter_mac_38=00:00:00:00:00:00
filter_mac_39=00:00:00:00:00:00
filter_mac_40=00:00:00:00:00:00
log_mode=disabled
log_ipaddr=0.0.0.0
chk_fw_hdr=enabled
fw_extension=fim
modle_id=LinksysWAP55AGv2
basic_realm=Linksys WAP55AG
restore_defaults=0
firmware_version=1.1
my_firmware_version=1.0.22, Jan 26, 2005
customer_firmware_version=1.1, Jan 26, 2005
wl0_macaddr=00:12:17:77:41:30
wl1_macaddr=00:12:17:77:41:31
lan_macaddr=00:12:17:77:41:32
ls
WAP55AG wlan0 -> ls
nvram          2881
apcfg          3981
config.bin     3863
apcfg.bak      3981
defaults         85
apimg1.hdr       52
defaults.bak     85
apimg1       968660
452608 bytes free