ASUS USB-N10 Nano

From TechInfoDepot
Jump to navigationJump to search
multiple revisions of this device, use caution
bgn (N150)
Wireless-N150 USB Nano Adapter
ASUS USB-N10 Nano.jpg
Homepage
Support
Downloads
WikiDevi.wi-cat.ru
Platform
BrandModelRev
ASUS USB-N10 Nano
Series
USB-N10
Interface
USB 2.0
Connector
Male A
Form factor
nano dongle
ID:0b05:17ba
Windows: USB\VID_0B05&PID_17BA
FCCID
none specified
Chip1
Realtek RTL8188CUS

OUI: none specified

MIMO status
1x1:1
Wireless Standards
IEEE 802.11b/g/n
802.11n
up to 150 Mbps
802.11g
up to 54 Mbps
802.11b
up to 11 Mbps
Operating Frequency
2.4 GHz

Windows driver
possibly see Realtek's website, but the majority of legacy drivers have been removed
know a better source? LMK

 Chip1 brandChip2 brand
ASUS USB-N10 NanoRealtek
ASUS USB-N10 Nano rev B1Realtek
ASUS USB-N10 v1Realtek
ASUS USB-N10 v2MediaTek

For a list of all currently documented Realtek chipsets with specifications, see Realtek.

For a list of all currently documented ASUS device with specifications, see ASUS.

150 Mbps - 1SS 2.4GHz 802.11n (40MHz chan.) = N150 class

Notes

Linux support notes

A user notes that disabling power saving, suggested by the README of rtl8192cu-fixes)

Sometimes Network Manager also sets a device in a power-saving mode where it doesn't use enough power to connect. You can fix it by editing `/etc/NetworkManager/conf.d/default-wifi-powersave-on.conf` and setting `wifi.powersave` to 2. And then reboot.

However, rtl8192cu-fixes currently reccomends at this point to abandon rtl8192cu completely for rtl8xxxu.

iw list dump
Debian GNU/Linux 7.9 (wheezy)

linux-image-3.16.0-0.bpo.4-amd64_3.16.7-ckt11-1+deb8u6~bpo70+1 (rtl8192cu)

firmware-realtek_0.43~bpo70+1 (rtlwifi/rtl8192cufw_TMSC.bin)

Wiphy phy0
	Band 1:
		Capabilities: 0x1862
			HT20/HT40
			Static SM Power Save
			RX HT20 SGI
			RX HT40 SGI
			No RX STBC
			Max AMSDU length: 7935 bytes
			DSSS/CCK HT40
		Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
		Minimum RX AMPDU time spacing: 16 usec (0x07)
		HT TX/RX MCS rate indexes supported: 0-7, 32
		Frequencies:
			* 2412 MHz [1] (20.0 dBm)
			* 2417 MHz [2] (20.0 dBm)
			* 2422 MHz [3] (20.0 dBm)
			* 2427 MHz [4] (20.0 dBm)
			* 2432 MHz [5] (20.0 dBm)
			* 2437 MHz [6] (20.0 dBm)
			* 2442 MHz [7] (20.0 dBm)
			* 2447 MHz [8] (20.0 dBm)
			* 2452 MHz [9] (20.0 dBm)
			* 2457 MHz [10] (20.0 dBm)
			* 2462 MHz [11] (20.0 dBm)
			* 2467 MHz [12] (disabled)
			* 2472 MHz [13] (disabled)
			* 2484 MHz [14] (disabled)
		Bitrates (non-HT):
			* 1.0 Mbps
			* 2.0 Mbps
			* 5.5 Mbps
			* 11.0 Mbps
			* 6.0 Mbps
			* 9.0 Mbps
			* 12.0 Mbps
			* 18.0 Mbps
			* 24.0 Mbps
			* 36.0 Mbps
			* 48.0 Mbps
			* 54.0 Mbps
	max # scan SSIDs: 4
	max scan IEs length: 2257 bytes
	RTS threshold: 2347
	Coverage class: 0 (up to 0m)
	Supported Ciphers:
		* WEP40 (00-0f-ac:1)
		* WEP104 (00-0f-ac:5)
		* TKIP (00-0f-ac:2)
		* CCMP (00-0f-ac:4)
		* CMAC (00-0f-ac:6)
	Available Antennas: TX 0 RX 0
	Supported interface modes:
		 * IBSS
		 * managed
		 * AP
		 * AP/VLAN
		 * monitor
		 * mesh point
		 * P2P-client
		 * P2P-GO
	software interface modes (can always be added):
		 * AP/VLAN
		 * monitor
	interface combinations are not supported
	Supported commands:
		 * new_interface
		 * set_interface
		 * new_key
		 * new_beacon
		 * new_station
		 * new_mpath
		 * set_mesh_params
		 * set_bss
		 * authenticate
		 * associate
		 * deauthenticate
		 * disassociate
		 * join_ibss
		 * join_mesh
		 * set_tx_bitrate_mask
		 * action
		 * frame_wait_cancel
		 * set_wiphy_netns
		 * set_channel
		 * set_wds_peer
		 * Unknown command (84)
		 * Unknown command (87)
		 * Unknown command (85)
		 * Unknown command (89)
		 * Unknown command (92)
		 * connect
		 * disconnect
	Supported TX frame types:
		 * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
		 * Unknown mode (10): 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
	Supported RX frame types:
		 * IBSS: 0x40 0xb0 0xc0 0xd0
		 * managed: 0x40 0xd0
		 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
		 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
		 * mesh point: 0xb0 0xc0 0xd0
		 * P2P-client: 0x40 0xd0
		 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
		 * Unknown mode (10): 0x40 0xd0
	Device supports RSN-IBSS.
	HT Capability overrides:
		 * MCS: ff ff ff ff ff ff ff ff ff ff
		 * maximum A-MSDU length
		 * supported channel width
		 * short GI for 40 MHz
		 * max A-MPDU length exponent
		 * min MPDU start spacing
	Device supports TX status socket option.
	Device supports HT-IBSS.