SanCloud BeagleBone Enhanced WiFi V1G

From TechInfoDepot
Revision as of 14:18, 16 July 2022 by ShadowBot (talk | contribs) (→‎top: clean up, replaced: 802dot11_prot → 802dot11_protocols, |802dot11_protocols = → |802dot11_protocols =)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search
bgn
BeagleBone Enhanced
Homepage
WikiDevi.wi-cat.ru
3rd Party Firmware
dd-wrt
Status Unknown
OpenWrt
Status Unknown
Tomato any flavor
Incompatible
Gargoyle
Status Unknown
Platform
BrandModelRev
SanCloud BeagleBone EnhancedWiFi V1G
FCC ID
none specified
Type
single-board computer
Wireless class
N150
CPU1
Texas Instruments Sitara AM3358
CPU1 Speed
1 GHz
Flash1 Chip
Micron MTFC4GACAJCN-1M
Flash1 Size
4 GiB 4,096 MiB <br />4,294,967,296 B <br />33,554,432 Kib <br />4,194,304 KiB <br />32,768 Mib <br />
RAM1 Size
1 GiB 1,024 MiB <br />1,073,741,824 B <br />8,388,608 Kib <br />1,048,576 KiB <br />8,192 Mib <br />
RAM1 Chip
Micron MT41K512M8DA-107 x 2
ETH chip1
Texas Instruments Sitara AM3358
ETH chip2
Atheros AR8035-A
Ethernet Port Count
1-1GbE-LAN

802dot11 OUI: 18:BB:26
Ethernet OUI: 7C:66:9D

Stock bootloader
U-Boot  2018.09
Stock FW OS
Linux 4.14.71 Debian 9
Expansion IF types
USB 2.0
USB ports
2
USB Hub Compatible
Untested
Power
5 VDC, 2 A
Connector type
barrel
5.5 mm (OD)
2.1 mm (ID)
9.5 mm (LEN)
Serial Port (UART)
yes, 3-pin header, populated, 3.3V TTL, (115200 8N1)
Flags
MicroSD Card slot, Micro HDMI, SPI, I2C, GPIO, temperature sensor, accelerometer, gyroscope, Bluetooth 4.0 (BLE)

Additional chips
4-port USB Hub Controller;SMSC;USB2514B;;1;
1K I2C Serial EEPROM;MicroChip;24LC01AT;;1;
Low-Power 3D HDMI Transmitter;NXP;TDA19988BHN;;1;
Six-Axis MEMS Motion Tracking Device;InvenSense;MPU-6050;;1;
Pressure Sensor;STMicroelectronics;LPS331AP;;1;
Single Chip PMIC;Texas Instruments;TPS65217C;;1;
1.7MHz, 1A, Step-Down Converter;ON Semi;NCP1529;;1;
1.8A Sink/Source Bus Termination Regulator;Richtek;RT9045;;1;
Single Inverter Buffer Driver;Texas Instruments;SN74LVC1G06;;1;
Single Positive Edge-Triggered D-Type Flip-Flop;TI;SN74AUC1G74;;1;
Dual Buffer and Driver With 3-StateOutput;TI;SN74LVC2G241;;1;
Current-Limited, Power-Distribution Switch;TI;TPS2051;;2;
ESD Protection Diodes with LC Voltage;ON Semi;NUP4201MR6;;3;
ESD Protection Diode for HDMI;NXP;IP4285CZ9;;2;

Categorized as
not categorized
Other
Default IP address
acquired via DHCP
Default login user
debian
Default login password
temppwd
3rd Party Firmware Support
Android 4.2.2, Arch Linux ARM • (List | DLs), Gentoo
Radio 1
Radio1 module
unknown
Radio1 module IF
USB (module)
Chip1
Realtek RTL8723BU
Wireless interface OUI
18:BB:26
Antenna Connector Type
none specified
MIMO status
1x1:1
Wireless Standard
IEEE 802.11b/g/n
802.11n
up to 150 Mbps
802.11g
up to 54 Mbps
802.11b
up to 11 Mbps
WiFi Operating Frequency
2.4 GHz

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Realtek chipsets with specifications, see Realtek.
For a list of all currently documented Texas Instruments (TI) chipsets with specifications, see Texas Instruments.

Overview

The board can be powered by 3 different methods:

  • 5V/2A power supply plugged into the connector
  • USB Female Micro-B
  • Expansion connectors

Bluetooth 4.0 (BLE), MicroSD Card slot, Micro HDMI output

Links of Interest

Flashing

Upgrading

Reverting

JTAG-Serial Info

USB Info

vlan Info

Pictures

Notes

Hardware Modification

See also

https://beagleboard.org/boards